Hardware Insights Forum

I recently bought an old Jetway board from fleabay which only went for $0.99. Anyhow, the caps on it look like they were bulged but have had the tops pushed back down, and one of them has electrolyte coming out the bottom. I'd say the seller did that just so it -looked- sellable. The caps in question are all GSC Brand (now known as Sacon). I'm gonna recap it since I know someone who just wants a cheap computer for light use.

that is absoultely hilarious

that guy's genius.

One of the customers to the computer store I work at had tried that once and "it's didnt seem to help" according to their distressed phone call

quite literall

yup

You got what I meant?
I meant that the hammer in the smilie was hammering down the capacitor tops to make them flat. Nevermind.

OK, so I finally got some replacment caps (mostly panny and rubycon, with 1 samxon GD series/Good series). You can see it on the test bench (Yes, that is my re-built 400W Rexpower PSU to the right) and in the hardware monitor section of the BIOS.

Several of the original GSC caps had bulging rubber seals. The 3rd one in from the left on the bottom row had electrolyte all over the seal.

you saved that board and it's alive again.